Tech Help - Empire Reloader B

Be sure to reference our manuals section
If you need the reader plug-in click here for installers.
To purchase any parts, please contact: 1.800.220.3222

Empire Reloader B Problems:

Empire Reloader Problems:

Does not turn on

Spins at high speed when turned on and won't shut off

This means the Circuit Board is defective and needs to be replaced.

Does not turn off





Breaks paintballs in the loader

The picture below with the red "X" shows a Drive Belt with too much grease applied.
The picture with the green check mark shows a Drive Belt with just the right amount of grease applied.

Feed Cone turns very slowly




Spins at startup but won't activate
when gun is fired

Your Circuit Board is bad.

Tech Help - Empire Reloader

Be sure to reference our manuals section
If you need the reader plug-in click here for installers.
To purchase any parts, please contact: 1.800.220.3222

Does not turn on

The battery is not installed. Make sure you install the two 9 volt batteries into the battery compartment with the positive side of the battery on the side of the shell with the (+) sign on the side of the battery compartment. Replace the cover.

Not Spinning

Any of the above problems you should send in the product to Paintball Solutions

Only spinning while holding the power button

The board in the loader needs to be replaced
Please call us for solutions to any of your paintball tech questions.

1.800.220.3222

or email: tech@paintballsolutions.com